all built prusa i3... still need help. :(

[klack]

IMG_20140302_133933212.jpg Hee is what my first actual print looks like.

[beerdart]

What filament and hot-end are you using?

[klack]

What filament and hot-end are you using?

I am using a .5 jhead and this filament is abs from makersfarm

[MeoWorks]

http://3dprintboard.com/showthread.p...a-8-quot/page2

Post 17

[DrLuigi]

I would highly suggest to take a look at those stepper drivers,
As they can be a bit to much/to low.

Doing this without a multimeter is quiet bad imo,

I noticed that even the slightest turn can make 0.4-5 diffrence easily without you knowing it,

And i had skipping when i was at 0.37.
Might test later on today on a dry run if it would happen again or not.
Probably i will just keep it at Z1 and repeat x50 y50 x150 y50 and make quick squares, So i can see if it has skipped.