Results 1 to 10 of 15
Hybrid View
-
03-04-2014, 12:53 PM #1
I would highly suggest to take a look at those stepper drivers,
As they can be a bit to much/to low.
Doing this without a multimeter is quiet bad imo,
I noticed that even the slightest turn can make 0.4-5 diffrence easily without you knowing it,
And i had skipping when i was at 0.37.
Might test later on today on a dry run if it would happen again or not.
Probably i will just keep it at Z1 and repeat x50 y50 x150 y50 and make quick squares, So i can see if it has skipped.Last edited by DrLuigi; 03-04-2014 at 01:04 PM.
Please explain to me how to...
Yesterday, 12:15 PM in 3D Printer Parts, Filament & Materials