Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 17

Thread: HICTOP PRUSA i3

Hybrid View

  1. 01-21-2021, 11:59 AM #1
    Roberts_Clif
    Roberts_Clif is offline
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,154
    Add Roberts_Clif on Thingiverse
    3DP11 Red is a 12 volt 3D Printer, while Blu is a 24volt 3D Printer.

    Red came with a Z-Axis end-stop manual switch, while Blu came with a Z-Axis inductive proximity sensor.
    Both have been upgraded to Omron low profile inductive proximity sensor.
    They are mounted on a spring loaded slide mount for quicker adjustments using a thumb screw.
    TL-W3M.jpg

    Designed a new cooling Duct for my heat sink attached to throat.
    This extends the throats life extremely well last replacement was almost a year.

    TL-W3M 3.jpg

    Old Slide Mount

    SN04N-1.jpg

    All modification
    I have made are available for download including all versions of Marlin modified for Hictop 3DP11/12.
    Last edited by Roberts_Clif; 01-21-2021 at 12:10 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules