I'm still fairly new to 3D printing, so sorry if I do a poor job explaining this issue.

When the printer lays down the initial line of filament at the front of the build plate before it starts the print, the line starts out oddly wavy. I also have a Makerbot and have never seen the Makerbot do this, so I'm not sure what the issue might be. Pictures attached to make this a bit clearer. The waviness seems to clear up by the end of the line, but I'm not sure what's going on and if it's affecting the rest of the print (as I've been having some problems with prints lately).

Printer: FlashForge Creator Pro (dual extruder) -- only printing with the right extruder right now
Software: Makerware
Filament: PLA

It did this with the default Makerware print settings, and also when I slowed down the first layer speed (as I was having some issues with the first layer adhering without a raft).

February 17, 2016 at 0257PM (1).jpgFebruary 17, 2016 at 0257PM.jpg