Results 1 to 4 of 4
Thread: X axis not moving
-
02-17-2016, 09:40 AM #1
- Join Date
- Oct 2014
- Posts
- 441
X axis not moving
Hello everyone, been very busy the past few months and have not had a chance to getting around and fixing my FF. I am not getting any movement on the X axis. I have spare motors, but have never swapped one of these before. Just wondering if someone has some tips, or a guide on how to remove them and replace. Hoping is the motor at least. Could be something else? Thanks
-
02-17-2016, 10:58 AM #2
most likely a loose or bad wire.
Given the vibration, not surprising if the odd connector works loose.
Check connections on motherboard and motor before changing motor. You got a multimeter to check there's not a break in a wire ?
-
02-17-2016, 11:24 AM #3
- Join Date
- Oct 2014
- Posts
- 441
I will check out the wiring when I get a chance. Just had my baby finally, been a hectic week+ :P
Was kind of hoping it was the motor, I have replacements of those :P
-
02-17-2016, 11:52 PM #4
Ya the rule of thumb is it is almost never the motor. lol
New to 3d printing looking for...
Yesterday, 12:56 AM in Tips, Tricks and Tech Help