Maximum Overhang?

[quertz]

Wow, that's a lot of stuff.

I think we should just open a new Thread here or on the Peachy forum.

50 microns seems pretty good to me, at least to compensate for long-term trends (using the dripper for high-res height-delta, the capacitance for low-res absolute height).

quertz

[rylangrayston]

Ya good Idea quertz...
ok here is a new thread for talking about capacitive feedback of resin height:
http://3dprintboard.com/showthread.p...4282#post84282

In this thread, lets go back to talking about maximum over hang.
and remember everyone starting a new thread for a new topic is good for everyone.. it makes things much easier to find later!