Quote Originally Posted by EagleSeven View Post
If I remember correctly there is a Firmware setting to select which nozzle is #0 and which is #1.
(new firmware may have the nozzles Reversed ? )
So, maybe if you switch those it will fix the startup location and keep them over bed-plate ?
Then select the correct nozzle in slicer software as primary (#0) and secondary (#1),
to select which to use when printing.
I've already worked out the issue, I was simply explaining what the setting was. This offset being set to 0 is a common problem upgrading to Sailfish in CTC printers. If you do a little googling, you'll see others with the same complaints. The reason I put the value 34mm instead of the other values you had listed was because his symptoms had matched mine from my update.
If you find that firmware setting, that would be great, as most software likes to default to the right extruder head, and I can't get my extruders level to each other so I primarily use the left.