I got my DaVinci 1.0 way back in August of 2014 and used it almost non stop till February of 2015 when I go my Flashforge Creator Pro. Since then I don't use the DaVinci as much. I was thinking about modding it and replacing the motherboard with a Mighty Board
http://www.flashforge-usa.com/shop/part … board.html I know I will need to replace the end stops and the hot end. But I should be able to use the stepper motors. I will also replace the heated bed with a better one. I would like to install the Sailfish firmware on it.
Just wandering if this will work or would it be a wast of time?