Hi Luca,

I tried getting in touch with you on the FB group you created then deleted, and also the OpenSLA community... but without being an "expert" at Linux and development, I would not recommend trying to use my firmware at this time. You can backup the old one. The best way to do this is to buy a second beaglebone black and install my firmware on the new BBB and leave the old one untouched.

Theoretically once I get the software worked out it should be the ability to use any resin. You would need to use a 3rd party slicing tool (I use slic3r right now and will provide the general settings I utilize).

When and if I think my firmware is ready for more prime time beyond just anyone with the capability to test it out and help development, I might be willing to offer BBB's with the firmware pre-installed in which case all you need to do is swap the BBB's and you would be up and running.