Today my supply is working better. I'm working on making a few gifts for my daughter for the holidays. She loves sharks so I picked out a few things from thingiverse and am trying to print them. So far I did a shark. I'm not using supports, so I ran into an issue that to secure the print to the build plate I run the laser at 8x time for the first 8 layers. That's a bit too conservative and I think I'm going to start trying to cut that down. I have the shark comb in my UV box, when it comes out I'll take a picture of it. You'll be able to see the over exposure from the first few layers. I'll also keep notes posted for each print. Some of them I used supports and some I did not. I didn't like the supports I was seeing in slic3r and that is what I'm currently using, for better or worse.

https://www.dropbox.com/sh/v4sj9ecdb...k%20gifts?dl=0