Results 1 to 9 of 9
Hybrid View
-
02-09-2019, 05:06 PM #1
- Join Date
- Jan 2016
- Posts
- 5
UPDATE:
Finally back into this but to help a friend make a copy of a tail light lens.
Friend was going this way MeshRoom > AutoDesk Fusion 360 > MeshMixer/Cura?Blender
I found
Tried 123D Catch - DISCONTINUED
Tried AutoDesk ReMake - DISCONTINUED
Tried AutoDesk ReCap - No Hobby License
... (!)
Problems seem that Fusion only allows 50k triangles and requires manual conversion from triangles to quads (which makes no sense to me - I'm not up to speed yet.)
QUESTION 1: Is this a good selection of software?
NOTE: I am a senior ProEngineer AutoMesh / NASTRAN FEM jock, so I know all that stuff.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion