Nightmare start

[d43d]

Yes definitely 0.2mm as I didn't change that from the default in Makerware... I'll up that 0.33mm put the temp down a bit to 205 degrees and give another attempt once clean..
Thanks a lot guys and I'll keep you informed how it goes!

[EagleSeven]

Yes definitely 0.2mm as I didn't change that from the default in Makerware... I'll up that 0.33mm put the temp down a bit to 205 degrees and give another attempt once clean..
Thanks a lot guys and I'll keep you informed how it goes!

Yes, increasing height to .33 will let you know if that is the problem.
Then you can lower it a bit until you are happy with the results.
I've found that differences in nozzles require slightly different layer height and width settings.
(Not all .4mm nozzles are exactly .4mm, as an example)