dstar.jpgdstar1.jpgdstar2.jpgdstar3.jpgHere are a few pics of my new print. Looks a bit under extruded on the sides but maybe over extruded on the top. Or maybe that's just because of the slicer. I guess this thread has just turned into a critique my print thread. I notice that the filament occasionally makes a faint crackly sound when being retracted. My retraction is at 3mm. Also, I printed at 100% flow and my e-steps are calibrated so my extruder is pushing the right amount of filament through (I measured). I am trying 110% flow just to see what happens. I appreciate any advice. Thanks. Here's some print info:
Print speed: 30mm/s
Nozzle Temp: 230 Celsius (high temp explained in first post)
Bed Temp: 60 Celsius
Filament: MakerFarm Black PLA
Layer height: 0.1mm (0.3 mm first layer)