I tried Windex, I think I am just to impatience. I sprayed and rubbed a glue mess lol. The gluestick wipes off with a baby wipe, or a shot of Windex. With print times being long I should realize I have plenty of time to clean the glass HEHE. The hair spray I used did not give me the same stick as the glue stick either.

I just read/watched about a bed pad to print on, zebra board I think it was called. No glue needed, and you can flex the board to pop prints off.

Fun is a total understatement! I have been printing from thingiverse a bit, making gliders, and creepers, batarangs, etc. I have my prototype printed out in abs, fully functional just needs more refinement in the operation. Then I can get that idea off the ground.

I am struggling to keep designing, all these free prints to download make it hard to focus...