Quote Originally Posted by Dguerne View Post
Yeah we dont need anything super High end more of just to get a rough part to start with them we can fine tune it from there. Is there any decent software out there that I could get for designing my figures? I would like to give my hand a try at making mini figs for Dungeons and dragons for myself and a couple of friends. The program i use at work is mastercam is more of a engineering and technical style so its hard to make nice flowing surfaces of like people.
I think you are over-estimating the stage 3D scan is at. Even with a high end scan and expensive soft, you can't do that without putting in lots of hours. I've seen our metrology dept work on a remodel project for the army, to make a case for an old equipment. Took them way too long to be cost efficient.