Results 1 to 10 of 24
Hybrid View
-
01-07-2016, 03:05 PM #1
- Join Date
- Sep 2014
- Location
- Brummen, Netherlands
- Posts
- 265
For ABS you need to turn the fan off (0 %) during the whole print. The fan is only usefull for PLA as it needs one. ABS definitely not as it has a very high glass point around 105 C (this is where it becomes rubbery) and the fan will cool it to below this way too fast.
As to the levelling, are you using a piece of paper to gauge the distance?
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion