Results 1 to 10 of 22
Thread: Ninjaflex Filament
Hybrid View
-
08-08-2014, 04:10 PM #1
- Join Date
- Sep 2013
- Location
- New Jersey, USA
- Posts
- 494
Does anyone know if there are issues with sticking? I imagine this stuff is harder to remove from the build tray then PLA or ABS. Am I current in this assumption? Just about to order a spool.
-
08-08-2014, 07:58 PM #2
As long as it does stick, unlike nylon 618, then I imagine you have no warp or lift issues because, it's flexible. It doesn't have enough inate rigidity to pull itself up I'd guess. I use a lot of single edged razor blades to remove parts. I just slide it under and edge and begin to wiggle. I'd much rather have a harder time removing a part then getting one to stay down, that's for sure.
Has anyone used it with a Wade's extruder? I have a Makerfarm Prusa i3 also and I'd assume the Wade's would be pretty good because the hobbed bolt is so close to the hotend. I've read that some of the other extruders that shove the filament through a tube for a few feet have trouble with compression and friction, thus hampering feed.Bambu P1S/AMS
NVision4D http://nvision4d.com
Please explain to me how to...
05-17-2024, 12:15 PM in 3D Printer Parts, Filament & Materials