Just updated my CTC printer and this video guide tells you exactly what to do!



Pressing the update button and the button on the back of the printer does take quite a few goes.
I found the best thing to use was the spare fuse I got with the printer to press the button on the printer.
But even then it took me like a dozen times before it updates.

As the video says, when you do the update, just tip the printer back a bit and see if the green light starts flashing.
If it doesnt and you just see the normal red light on, wait for the program to say update has failed and try again.

Again, dont forget to stop makerware services when using repg
And apparently best to stick with 7.6 even though there is a 7.7 out, as there are sd card problems with 7.7 or something.

You can get the lates sailfish regp from http://www.thingiverse.com/thing:32084/#files


It hasnt however fixed my circles coming out as ovals