Results 1 to 3 of 3
-
12-26-2015, 10:29 PM #1
- Join Date
- Dec 2015
- Posts
- 2
Replicator 5th Generation stopped working
Hi all,
My 3D printer stopped working.
Do not turn the control panel, this distinguished forum someone could give me some solution or clue about it?
-
01-10-2016, 11:42 PM #2
- Join Date
- Jun 2015
- Posts
- 2
Have you taken the cover off? There's an HDMI cable that connects the front display to the electronics at the bottom rear of the printer. Might be worth checking to see if that's plugged in.
-
01-11-2016, 04:01 PM #3
- Join Date
- Dec 2015
- Posts
- 2
Hi Hargakanay,
Just check the HDMI cable is connected. The control panel does not turn, I think it was burned !!!
New to 3d printing looking for...
Yesterday, 12:56 AM in Tips, Tricks and Tech Help