Results 1 to 10 of 10
Thread: RADDS Info Thread
Hybrid View
-
12-27-2015, 09:17 AM #1
- Join Date
- Aug 2015
- Location
- Vail, CO, USA
- Posts
- 36
The first problem I hit is related to z homing. The X and Y axes home fine, but when I press the "Home Z" button in Cura, the Z motors only make a high-pitched squealing sound. I think this problem is firmware-related so I will look around in the Repetier firmware for a little longer.
-
12-27-2015, 10:25 AM #2
Last edited by printbus; 12-27-2015 at 10:40 AM.
-
12-27-2015, 10:41 AM #3
- Join Date
- Aug 2015
- Location
- Vail, CO, USA
- Posts
- 36
Z homing feedrate is actually lower than my Marlin setting, I don't think that's the problem. However, the Z axis does move normally when not homing so perhaps another homing related setting is off?
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion