Results 1 to 10 of 53
Thread: New CTC Owner
Hybrid View
-
12-26-2015, 07:51 PM #1
- Join Date
- Dec 2015
- Posts
- 80
I think its definately the belts.
warping happens even when printing a simple washer.
Created another thread in the feedback section, http://3dprintboard.com/showthread.p...oming-out-oval
Just need to find out how to tighten the belts now.
-
12-27-2015, 07:44 AM #2
Do your belts have these little Springs on them ?
(They are on our printer and keep them tight)
If not, you can get them at eBay.
belt springs.jpg
Could the problem be a loose pulley or shaft, that belt rides on ?
Check to see if the stepper-motors are loose at mountings in case,
(I've read about a loose Y-motor causing problems)Last edited by EagleSeven; 12-27-2015 at 07:56 AM.
-
12-27-2015, 06:19 PM #3
- Join Date
- Dec 2015
- Posts
- 80
But how do I do that? Cant find any videos on youtube of anyone showing it.
And it did come with one tentioner on each y belt. tried to adjust and now cant get spring back on.
Any tip of putting them on without getting stabbed?Last edited by bigo93; 12-27-2015 at 07:34 PM.
-
12-28-2015, 06:43 AM #4
??? What are you asking about ?
If the Y-stepper-motor, then it mounts to case with 4 screws, thru standoffs.
Those mounting screws adjust belt-tension and can come loose, allowing motor position to rotate.
(The short belt at Y-stepper-motor does not have a tension-spring on it)
One spring on each belt should be enough.
Don't want to Over-Stretch the belts !
Yes, getting them on is Not real easy.Last edited by EagleSeven; 12-28-2015 at 06:57 AM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion