I got one of the dual extruder printers about a month ago. It worked pretty good out of the box. Still tweaking it with each print The nozzle got clogged and filament stopped feeding and the gears kept turning and dug into the filament, breaking it. I replaced the nozzle and cleared out the broken pieces of filament. Now it does not work. I start it up and the extruder and bed heat up it prints the line that gets the filament going and then starts the print, beeps once and stops. I tried doing other calibration procedures like leveling the bed to see if I could get through the whole process and it did the same thing. The extruder would move to two points then beep once and not move again.

Anyone have any idea of what is happening?
thanks in advance