Results 11 to 12 of 12
-
01-01-2016, 07:54 AM #11
If Anyone here has upgraded their Firmware to Sailfish, in a CTC-Bizer, Please let us know ??
(I think version-7.5 is latest but not sure about that)
So far, I'm only finding Negative reports about trying to do that !
(mostly problems timing the Reset-button press)
And No improvements in print quality over original firmware.Last edited by EagleSeven; 01-01-2016 at 08:18 AM.
-
01-27-2018, 09:06 PM #12
Hello
I have just upgraded my CTC Dual to Sailfish 7.6, it was a little challenging with the reset button, but after going through all the firmware upgrades to get it to the Sailfish firmware its definitely made a huge difference.
I was on the original firmware version 1.0, now I am using Sailfish 7.6, just brilliant.
Well worth the time to do it..
My 3D Norn Emissary print
09-13-2024, 02:28 AM in 3D Printing Gallery