Subscribe to Our Newsletter Advertise
Close



Results 1 to 7 of 7

Hybrid View

  1. 12-18-2015, 11:50 AM #1
    Chadd
    Chadd is offline
    Engineer-in-Training
    Join Date
    Feb 2015
    Posts
    211
    My 12" draws much less than 30A, I can't remember for sure but I think it was in the high teen range. I don't have my meter here at home but will grab it and check it to see for sure.

    Quote Originally Posted by spaceorange12 View Post
    my 40a is probably overkill for any printer
    some people have recorded 12"s like mine to pull somewhere around 30a (worst case) so i am definitely on the safe side as far as current goes.
    the thermistor is secure on the bottom of the bed.

    i think the problem is either in the firmware or on the RAMPS.
    im getting a RADDS board soon which has some higher quality components so well see.
    Last edited by Chadd; 12-18-2015 at 06:57 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules