Hello,

When i wanted to load my right extruder and All i got was a clicking noise. Checked the gears on the stepper motor, no problems there....So I undid the nozzle and found my teflon tube blocked...this was yesterday, so I heated up a safety pin, poked around and managed to get the black stuff free from it. The tube was still straight and so I put it back in...

Now again the teflon tube is melted at the tip in the shape of a sharp pencil (because since i was having a problem loading i heated up the preheat setting in the extruder at 250 against the normal 230)...

Can i cut the melted part away and say use half of the other part that is still OK? Or does it need to be the same length as the original tube?

Thanks for the help..

IMG_4390.jpg