Results 11 to 20 of 23
-
12-09-2015, 12:09 AM #11
-
12-09-2015, 06:25 PM #12
Where did anybody say "too complex to design" ?
I went ahead and designed it, finished it, printed it (took 3 revisions) and installed it. It's working in my fridge as we speak
Just had to simplify it a bit....and stop being lazy.
-
12-09-2015, 07:30 PM #13
-
12-10-2015, 09:19 AM #14
-
12-10-2015, 03:20 PM #15
- Join Date
- Nov 2013
- Posts
- 29
Umm you did in the subject header of your post, "
Frigidaire Part - Too complex need scanned"
If your going to play semantics then you really should heed Aardvarks advice.
-
12-10-2015, 05:46 PM #16
This is not easy....but.....
Placebo.....I forgot ALL about the title.....didn't even look at the title again. oh boy...now I see wheer I went wrong.
ok.
I'd like to apologize to Aardvark and accept that I did something REALLY stupid here....and failed to see it until Placebo pointed it out.
I could not understand how Aardvark thought I was wrong....until now.
I was getting defensive and honestly forgot I said "too complex" in the title. Was only looking at the body of the message.
Thank you Placebo for showing me exactly where I went wrong. I understand now. I'm feeling old age taking a toll on me.
I hope I don't continue to make foopahs like this. Concerned.
-
12-10-2015, 05:49 PM #17
- Join Date
- Jun 2014
- Location
- Burnley, UK
- Posts
- 1,662
-
12-10-2015, 05:53 PM #18
- Join Date
- Nov 2013
- Posts
- 29
I don't know for sure but I think CA will appreciate you owning up to an honest mistake. I know I certainly do. Accountability seems to be a rare occurrence these days. Thanks Ward!
-
12-10-2015, 06:31 PM #19
You guys are really decent. Thanks for the kind words.
I will take the advice.
-
12-10-2015, 06:57 PM #20
Let's see a picture of the original part and the replacement part!
My 3D Norn Emissary print
09-13-2024, 02:28 AM in 3D Printing Gallery