Results 1 to 4 of 4
-
12-16-2015, 05:51 PM #1
- Join Date
- Nov 2015
- Posts
- 21
What material to use for VESA tripod adapter?
I am needing a VESA tripod adapter, and I found one on thingiverse that might do the trick:
http://www.thingiverse.com/thing:667265
If I were to print this design, what material should I use? It will attach to a specialized tablet holder weighing about 3 lbs.
-
12-17-2015, 02:03 AM #2
Unless the thing heats above 40°C, pretty much anything goes as long as you ensure the proper fill and perimeters.
If it does heat above 50°C, try PET, nylon or ABS.
-
12-17-2015, 10:54 AM #3
-
12-17-2015, 03:04 PM #4
- Join Date
- Aug 2015
- Posts
- 256
Hmmm... the layer orientation would make me worry about it splitting and dropping the monitor on the ground. I would probably modify this into a two part object, so I could rotate the block that attaches to the tripod rotate 90 degrees, and then glue it to base that attaches to the monitor.
New to 3d printing looking for...
Yesterday, 12:56 AM in Tips, Tricks and Tech Help