Subscribe to Our Newsletter Advertise
Close



Results 1 to 6 of 6

Threaded View

  1. 12-02-2015, 03:57 AM #1
    pgx3s
    pgx3s is offline
    Student
    Join Date
    Dec 2014
    Posts
    21

    Question Undesired filament retraction at beginning of a print

    Hi there

    A lot of times I extrude some material for testing and adjusting in front of an actual print.

    Since a while I have to shut the printer off again before I start the print. If not most of the time the extruder retracts a lot of filament after zeroing the z axis.

    That happens with ocotprint and simplify3d.

    Printer: Makerfarm Prusa i3v 12"
    Controller: Rumba
    Firmware: BeckDacks

    Any ideas?

    BR
    Manuel
    Last edited by pgx3s; 12-02-2015 at 04:43 AM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules