Hey Guys

The printer I inherited has now been completely rewired, and is ready to be calibrated, However my knowledge of this step is next to none
What are the steps i need to take to ensure that I don't write the printer of at first print? I'm guessing this would require maximum and minimum limits as well as Datums to be set.

The printer is a MendelMax 1.5 running Ramps 1.4 board and Marlin config.

So really what im asking is how do i go about getting the printer ready to print?

Also what printing software do you guys favor? As there area many different programs i have seen

Many many thanks in advance

Ramjam