Quote Originally Posted by Roxy View Post
Sorry... It is hard to keep everything straight. Yes, M119 is correct. And once the correct behavior is confirmed, you should be able to move the carriage (with the motors off) to verify that the end-stops trigger as they should.

You will be printing soon.....
What should i be seeing with my end stops in the configuration that they are? This is what i get when all are not activated and the axis mins change to open when activated. Is this correct for Normally Closed operation?

>>>M119SENDING:M119
Reporting endstop status
x_min: TRIGGERED
x_max: open
y_min: TRIGGERED
y_max: open
z_min: TRIGGERED
z_max: open

Sorry for all the questions not a subject ive had an experience in until now :/