Results 1 to 10 of 18
Threaded View
-
11-27-2015, 01:43 AM #2
The advantage of 3D printing is you can iterate as much as you want for a small cost.
Use good engineering judgment : make it 5mm thick, use 3 shells. For materials, use nylon or PETG. PLA melts too low, if the table heats a bit, you'd take risks. For a wide flat part like this ABS is not the best choice and might be tricky to successfully print.
If it doesn't work, try again ;-)
Please explain to me how to...
Yesterday, 12:15 PM in 3D Printer Parts, Filament & Materials