Results 1 to 4 of 4
Hybrid View
-
12-14-2015, 12:43 PM #1
- Join Date
- Nov 2014
- Location
- New Orleans
- Posts
- 50
Have you fixed this yet? It looks to me like you have some pretty bad over-extrusion. Your e-steps are only half of the solution for extrusion, you will need to adjust (lower) your extrusion multiplier in whatever slicer you are using. While fixing your over-extrusion will lesson the seam seen in your second photo you can also help with reducing your retraction on layer change slightly until it is no longer as noticeable.
Please explain to me how to...
Today, 12:15 PM in 3D Printer Parts, Filament & Materials