Results 1 to 6 of 6
Thread: CTC Problem with the Layers
-
11-23-2015, 10:12 AM #1
- Join Date
- Nov 2015
- Posts
- 6
CTC Problem with the Layers
Hello Community !!!
Do you know the cause of this problem ??? I dont know what this is...
Firmware is Sailfish 7.6.
It suddenly happened after i put a new filament in the printer. I checked like 7 or 8 Roles and always the same.
Thanks for your help !!
20151123_170539.jpg
-
11-23-2015, 11:56 AM #2
-
11-23-2015, 12:17 PM #3
I use S3D and have used there support page for help in these types of issues. What slicer are you using?
-
11-23-2015, 12:44 PM #4
- Join Date
- Nov 2015
- Posts
- 6
Hi guys !
This problem comes with every file im trying... Im using Makerbot Desktop to slice my things. Its directly connected to my computer.
-
11-23-2015, 02:00 PM #5
What filament type are you using that is not working ?
What is nozzle-temp setting?
Temp may be set way too high or the Actual temp is Higher than displayed on printer,
and boiling the filament ?
My printer Displays about 15 C lower than Actual temp at nozzles,
so I use a digital thermometer, with thermocouple-probe, to get Actual temp.Last edited by EagleSeven; 11-23-2015 at 02:06 PM.
-
11-23-2015, 02:54 PM #6
- Join Date
- Nov 2015
- Posts
- 6
Nozzle Temp. : 220°C
Filament isnt boiling but i found something. When i change the Filament the Filament extrudes normally but then it stops for like 1 or 2 seconds or is going slower.
Please explain to me how to...
05-13-2024, 03:08 PM in 3D Printer Parts, Filament & Materials