SLA Resin Printer issue

[awerby]

Try a thicker raft?

[dunginhawk]

So the big downfall to this chinese printer (duh) is no software... so there is no built in support/raft etc.
It uses Cura, which works, but you have to do all the editing somewhere else, like creation workshop , s3d or boc. If i make a bigger base, it wont treat it as a raft coming in from another software, and thus will be fully bonded like any other layer. nearly impossible to remove without damaging the part.
im going to TRY lowering the bed just a bit so it doesnt grip as hard, but i doubt thats the answer.