bizarre problem w/Creator. Suddenly won't print to certain area of the bed.

[roykirk]

Here's a short video clip I've uploaded that shows the problem a bit better: https://youtu.be/PjKVwhcy28s

[roykirk]

Sebastian - You had it nailed! The problem was with some wires. They weren't rubbed through or anything, but part of the wiring harness was catching on a bolt, and this was putting just enough tension on the right extruder wiring that it was causing the connector to pull just a little bit askew...enough to make it start chattering when it got to the far left. I found this out rather by accident as I've been going nuts all morning trying to troubleshoot. While watching the carriage move to the left for about the 15th time, I noticed the wiring harness would momentarily grab that bolt when it went to the left. I lifted it up on the next pass and it printed fine. I've now secured it up and out of the way better. Thanks, Sebastian!