Results 1 to 7 of 7
Hybrid View
-
11-14-2015, 03:44 PM #1
Hi,
I was about to say it could be residual ooze, but hearing in your video that the extruder is working...
Just out of curiosity, what speed have you set ? Try reducing to 30mm/s for starters.
Have you put in your slicer a height max (stop printing over this height) ?
Do you have an end code (like go to X0,Y0) ?
If the motors are hot and it is none of the above, it might be board or motor issue.
-
11-15-2015, 11:07 PM #2
- Join Date
- Nov 2015
- Posts
- 4
I beleive this is the end code
Code:;End GCode M104 S0 ;extruder heater off M140 S0 ;heated bed heater off (if you have it) G91 ;relative positioning G1 E-1 F300 ;retract the filament a bit before lifting the nozzle, to release some of the pressure G1 Z+0.5 E-5 X-20 Y-20 F{travel_speed} ;move Z up a bit and retract filament even more G28 X0 Y0 ;move X/Y to min endstops, so the head is out of the way M84 ;steppers off G90 ;absolute positioning ;{profile_string}
Please explain to me how to...
05-13-2024, 03:08 PM in 3D Printer Parts, Filament & Materials