Originally Posted by
LambdaFF
Hi,
I was about to say it could be residual ooze, but hearing in your video that the extruder is working...
Just out of curiosity, what speed have you set ? Try reducing to 30mm/s for starters.
Have you put in your slicer a height max (stop printing over this height) ?
Do you have an end code (like go to X0,Y0) ?
If the motors are hot and it is none of the above, it might be board or motor issue.
I beleive this is the end code
Code:
;End GCode
M104 S0 ;extruder heater off
M140 S0 ;heated bed heater off (if you have it)
G91 ;relative positioning
G1 E-1 F300 ;retract the filament a bit before lifting the nozzle, to release some of the pressure
G1 Z+0.5 E-5 X-20 Y-20 F{travel_speed} ;move Z up a bit and retract filament even more
G28 X0 Y0 ;move X/Y to min endstops, so the head is out of the way
M84 ;steppers off
G90 ;absolute positioning
;{profile_string}
Does that mean anything? Speed was at 40, I lowered it to 30. I don't know how to put a height limit, although it does this after like 3 layers usually, so I don't know how that would be a problem. I'e successfully printer like 3 things so far of various heights. Is there anther software I should try or should Cura be the best?
Please explain to me how to...
05-17-2024, 12:15 PM in 3D Printer Parts, Filament & Materials