Results 1 to 10 of 12
Threaded View
-
02-14-2014, 04:11 PM #5
I use blue painters tape for PLA. If I have a print that is thin walled or if I am worried it might lift, I wipe the tape with a alcohol wipe first. This make it stick like crazy! I usually have to pry the tape up with the part and then peel off the tape. The down side is you use a lot more tape, the up side is that the tape is cheap and I get 99.9% success.
Last edited by JohnA136; 02-15-2014 at 08:56 AM. Reason: typo
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion