"Printer failures" that I can think of:
- Adhesion failure - will probably happen just because you started with slightly too much water in the printing container. However, this is not really an issue - it's obvious after the first layer. Unlike FDM printers, you shouldn't get adhesion issues on subsequent layers.
- Jamming up - there's three moving parts in the Peachy, if you count the water. If the water jams up then you've got a very curious problem. The mirrors themselves are unlikely to be an issue.
- Software fault - probably the most likely cause. End-users will find all sorts of really horrible things you can do that the software won't handle well at first. Luckily software is easy to fix and/or work around.
"User failures" that I can think of:
- Failed to plug in the audio cable
- Failed to plug in the power cable
- Wrong amount of water in the tank at the start
- Insufficient resin in the tank
- Printer is moved during printing, causing waves in the tank
- Incorrect alignment causing distortion
- Drip speed set wrong
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help