Quote Originally Posted by Mjolinor View Post
It cannot be done like that. The whole Gcode is geared to the amount that is extruded at any instant, it has to be in the Gcode as far as I can see anyway.

Fit the same size nozzles to all the machines.
I tried, the nozzles are different by such a small amount that I can visually tell the difference. I get a 5 pack of 0.5mm nozzles from china and some of them overextrude badly. I need to get 0.4mm and drill them out with my 0.5mm drill bit but even then its not exact.