I need some serious help

[Nickschaos81]

it doesnt go quiet as far, still got a gap maybe .5 ish

Would it be better if I set my distance higher then i actually have that way i can see the difference it takes to get tension on a sheet of paper at each point?

[LuckyImperial]

it doesnt go quiet as far, still got a gap maybe .5 ish

Would it be better if I set my distance higher then i actually have that way i can see the difference it takes to get tension on a sheet of paper at each point?

No you can just eyeball it for now.

If you have the same height issue (too high) at G1 Z0 X-30 Y-50 then you need to make your smooth rod offset smaller by 1mm. I believe with RC Marlin it's: M666 Rxxx. Don't forget to save to eeprom with an M500 and do a G28 before testing again.

[Nickschaos81]

do that from repiteir? yes?

[LuckyImperial]

Oh you use Repetier? Yes, but the commands are different. Do you have Repetier-Host? You can change the eeprom settings with it really easily. You'll still have to G28 after you make the changes though.