I sat down , and started to just go thru the eeprom list and find out what each thing was.... then i sat down and started to measure everything and comparing it to what was in the eeprom (that was based on manufactor instructions) .... had some descrepencys , and now it seems that I had things off and didnt understand what numbers where super important , and just important. Im printing some more calibration cubes right now. If they come out like i expect them too , and the calibration circle tool does good as well. Im going to then post a final post explaining what i have learned and hopefully it will help some else out there as well. Stupid math , should paid attention in school instead of checking out chicks.