Results 1 to 10 of 101
Thread: I need some serious help
Hybrid View
-
10-20-2015, 10:28 PM #1
- Join Date
- Oct 2015
- Location
- Great Falls Montana
- Posts
- 52
montana usa
okay guys here is where I am at. I have almost rebuilt this whole thing. I followed the guide that came with it and adjusted the carrage screws but when going to adjust the #delta_smooth_rod_offset it says to do it in increments of 0.x , It does not matter which way i adjust it i get no change of bringing my Zm to my Zz (currently Zm = 10.6 and Zz = 10.3) I have adjusted that offset as much as 20 or 30 mm either direction and it still does not change. Just to clarify the situation , I dissconnect from repitier upload new sketch , restart printer , reconnect with repitier , home , m114 , g1 z20 . then i take z down till i get tension on paper , then back off .1mm . So yea i dont know what to do at this point on this thing. any reason it would not change? any ideas?
Please explain to me how to...
05-17-2024, 12:15 PM in 3D Printer Parts, Filament & Materials