https://www.dropbox.com/s/d89247ymvg...31746.jpg?dl=0
https://www.dropbox.com/s/9330fvc76l...25158.jpg?dl=0
https://www.dropbox.com/s/5qkh0149m6...25124.jpg?dl=0

I think my prints are improving. You guys agree? lol especially from where I started. So it seems after I adjusted my steps other calibrations were thrown off lol , so the little 2 piece sub there has some bowl shape too it , I checked after print and yes those calibrations have been thrown off. No big deal.
So here is my game plan and a couple more quick questions.
Im going to double check steps per mm are as close to dead on as possible
going to do a manual bed leveling and then adjust my diagnol and horizontal settings again to elimenate dishing, or bowling w/e its called
then double check my total z height
then triple check all points to make sure we are homed in, including e Steps which brings me to my first question
1. Increase or decrease esteps to reduce how much extrudes ( I think decrease but i could have sworn i read increase some where)
2. how do i check to make sure steps per mm is correct on x and y ( mark bed , move head and measure? and if so what do i adjust to fix it if its off?)
3. How do i post pics in this forum so i dont have to use dropbox anymore?
4. anything else you guys can think of ?
5. autolevel? should i use it ? lol and if so , how?

Again , thanks you guys your awesome! wouldnt be were i am with out yalls