Micromake kossel printer - auto level problems

[Roxy]

The firmware flashed from Cura is repetier, a pre-compiled version of it I guess.

I tried editing my own Marlin firmware from the latest version, but as I moved further down the config.h, I read that auto level on deltas aren't implemented, is this so? Or did I misunderstand something.

Auto Level exists on Delta printers. But it works a little bit differently. Do you have a Z-Probe? You need a Z-Probe to do Auto Bed Leveling with Marlin.

[Stigern]

Auto Level exists on Delta printers. But it works a little bit differently. Do you have a Z-Probe? You need a Z-Probe to do Auto Bed Leveling with Marlin.

Yes, Micromake has this strange Z-probe, which actually is the whole extruder hitting bed, then moving extruder upwards releasing a micro switch.

Seller told me the marlin firmware was the old one, so the correct one is the one i flash using cura.
Also he told me to turn the belt-pieces upside down to correct the movement direction problem.

Gonna try this later and see if it fixes the home problem.