Results 1 to 7 of 7
Hybrid View
-
11-03-2015, 12:42 PM #1
Finally got mine to reset in the correct direction.
When doing auto level, at Print Height under Firmware setting it was set to 200 by default. If I used this setting it would stop in the middle and to auto probing in the air. Had to change this to 360 to get it close to bed.
Now when I try to run auto level it won't sense my probe. Maybe someone can check out this video and see if they see a reason:
PS Proble click fine, and running G31 command in pronterface shows it as L and H.
But still nothing when auto level procedure is run.
But what I find strange is when it's runnig the auto level procedure it moves to a new probing location when it's at its lowest point. Shouldn't it move upwards before moving to a new probe location?
Check video:
https://www.youtube.com/watch?v=MU2dwdouXVk
Please explain to me how to...
05-13-2024, 03:08 PM in 3D Printer Parts, Filament & Materials