Close
Flash Forge Inventor Series



Results 1 to 2 of 2

Thread: print bed crown

  1. #1

    print bed crown

    I just received my f306 today. It has a bad crown in the build plate. Heating the bed does not help. Has anyone ese had this problem?

  2. #2
    Yes. Glass is an amorphous solid so it will warp from inconsistent pressure from the springs underneath the bed. I have a few beds that I cycle through about every month. I just leave them on a flat surface until they are flat again.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •