Speed test: 100mm/s.. Drivers get a bit warm when running 100-120mm/s for a length of time but I have some upgraded ones coming in the mail..


After a few days tuning my drivers / motors and dialing in my firmware, I started to get some good prints!

PLA
Nozzle 190 *c
Glass Bed ( with tape no heat bed )
60 mm/s
0.35 First Layer Height
0.2 Layer Height
0% Infill Pink Panther ( 20% Hexagon Infill For 3DBenchy )
3 perimeter layers









I should probably start a build thread or something for this vs cluttering up this thread... lol sorry guys.