As topic suggests, my heat bed is not working at all. Shows as trying to heat up, but does not. Just hovers around 12-15 degree's. I posted about this in another forum but it was actually a separate topic. I unplugged this from the back of the heat bed (hopefully I can get it back in, was quite hard to get out, can't seem to pull the plug-in from the case). Looks kind of burnt to me right? IMAG2015.jpg I see this replacement cord on FFusa website for $8, but not sure if that is the problem, trying to find out before I order it.

I just ordered a 2nd printer today (CTC 3d pro) for $450 on Ebay new. Looking for the best 40mm fan I should get for it also, if anyone has a recommend fan. Thanks for any replies.