Results 1 to 2 of 2
Thread: Adventurer 3 Issue
-
08-31-2019, 07:06 PM #1
- Join Date
- Aug 2019
- Posts
- 1
Adventurer 3 Issue
Have had lots of good prints over several months, then all of a sudden PLA wont stick to surface, had tried cleaning, glue stick, still nothing.
Any ideas?
20190831_185526.jpg
-
09-04-2019, 05:11 AM #2
nozzle is too close to the bed.
It probably needs calibrating.
The flashprint software doesn't allow for increasing the z-gap (or if it does, I've yet to find the setting and I've really looked recently).
With my machines I use simplify3d on I'd just add 0.1 or 0.2 to the z-gap and that would fix it. With my knp, which i use flashprint on, I have to manually adjust the bed calibration - which is annoying.
But that's what causes that crinkling effect on the first layer, head too close to bed.
My 3D Norn Emissary print
09-13-2024, 02:28 AM in 3D Printing Gallery